Woodstock Shop Fox W1805, Руководство пользователя

Страница: 27 / 48

-25-
Model W1805 (For Machines Mfd. Since 7/15)
O
PE
R
ATIO
NS
Tail.Thickness
Figure.33 shows the tail thickness.
The tail thickness is controlled by adjusting the tracer pin
when it is in the "out" position on the template bar, as
shown in Figure.34 .
To.set.the.tail.thickness,.do.these.steps:
1. DISCONNECT MACHINE FROM POWER!
2. Draw a small pencil line on the edge of the vertical
workpiece approximately
1
⁄
16
" from the side of the
workpiece (see Figure.35 ).
3. Install the vertical workpiece so the side of the
board closest to the pencil line is facing out, as
shown in Figure.35 , and clamp the workpiece into
position against the vertical fence.
4.
Connect the spring to the headstock.
5.
Move the headstock just to the right of the
workpiece, and put the tracer pin in the "out"
position on the template.
6.
Stand to the right-hand side of the machine, and
look across the table at the cutter relationship to
the vertical workpiece. This viewing position will
help you align the cutter with the workpiece during
the next step.
. Note:
Familiarize yourself with the tracer pin
controls shown in Figure 36 if this is the first time
you have adjusted it.
Tail Thickness
Figure.33..
Example of tail thickness.
Out
Position
In
Position
Tracer Pin
Template
Bar
Figure.34..
Tracer pin positions on
template.
Table
Vertical
Workpiece
1
⁄
16
"
Pencil
Line
(Side View)
Figure.35.. Pencil line location on vertical
workpiece.
Figure.36..
Tracer pin controls.
Lock
Adjustment
Thumbwheel
Continued on next page