Woodstock Shop Fox W1669, Инструкция по эксплуатации, Страница: 20 / 44

-18-
This drill press will perform many types of oper-
ations that are beyond the scope of this manual.
Many of these operations can be dangerous or
deadly if performed incorrectly.
The instructions in this section are written with
the understanding that the operator has the
necessary knowledge and skills to operate this
machine. If at any time you are experiencing
difficulties performing any operation, stop using
the machine!
If you are an inexperienced operator, we
strongly recommend that you read books, trade
articles, or seek training from an experienced
lathe operator before performing any unfamiliar
operations. Above all, your safety should come
first!
To.start.the.drill.press,.do.these.steps:
1. Make sure the starting switch paddle is
down for OFF .
2.
Make sure all fasteners and lock handles are
tight.
3. Make sure the drill chuck key is removed.
4. Plug in the power cord.
5. Lift the
ON/OFF
switch to start the drill
press, and make sure that your fingers are
poised near the paddle, as shown in Figure.
30..
In case there is a problem you can turn
the drill press off.
6. Observe and listen to the drill press, it
should run smoothly, with little or no vibra-
tion or rubbing noises.
• If you hear strange or unusual noises, shut
the drill press OFF , and wait for the spin-
dle to stop moving.
7.
Unplug the drill press and refer to the
“ Troubleshooting ” table on Page.27
to help isolate and correct the problem
before using the drill press again.
Figure.30.. Fingers poised near the stop switch.
WEAR.safety.goggles.and.
a.respirator.during.drill-
ing. or. sanding. opera-
tions.. Otherwise. seri-
ous.personal.injury.may.
occur!
Keep. your. shop. “Child.
Safe.”. Always. remove.
the. switch. safety. key.
when.drill.press.is.not.in.
use.. Serious. injury. may.
occur.
Test.Run
OPERATIONS
OPERATIONS