woodmizer PH365, Инструкция по эксплуатации

Страница: 9 / 26

9
Grinding
To regain steels sharpness can be
brown
steel flat side. Thereby retaining steel
pair the same profile. If the steel is
damaged or needs to be ground up
using
normally an orbital sander with
magnetic chucks. The surface
towards the edge sanded down normal
0.1 mm.
Mounting and height adjustment
When eg tongue and groove is planed,
it is
important that these are the same
height
across the table.
Install the cutter at an approximate
height.
Test drive a board. Measure with
calipers,
adjust the height with washers.
Write down the setting on a test piece.
Side cutter set with
shim rings to the desired height.
The shim rings included:
3 x height 40 mm
2 x 20 mm
2 x height 10 mm
1 x height 5 mm
2 x height 2 mm
1 x 1 mm height
1 x height 0.5 mm
2 x height 0.2 mm
1 x height 0.1 mm
a cutter
With the shim rings, you can then
adjust the height as desired.
Adjusting the fence at vertical cutter
right. No. 2
The front fence pos 220 controls how
much the cutter to harvest. Normally
you let the fixed cutter take 2 mm.
Felling adjusted with lever pos 216 and
locked with lever pos 223
Rear fence
Rear fence pos 34 is fixed with 6 mm
screws on the mounting blocks in its
angular position.
Fences with 13 mm hex screws on the
mounting blocks in its lateral
movement.
There are also micro-adjustment on
the fence. When the hexagonal screws
loosened
one can handle the micro-adjustment
rotated.
If the fence is adjusted laterally unload
only 13 mm hex head
If the fence is adjustable in angle
loosen both hex head bolts and
screws.
If the fence shall be adjusted in the
longitudinal direction
remove only the hexagonal screws in
the fence opening.
Method
-Loosen the screws.
-First adjust the back fence so that
it is level with the cutting edge flight
diameter. (Minimum flight diameter in
steel profile).