woodmizer PH365, Инструкция по эксплуатации

Страница: 6 / 26

6
Installation and setup of
cutters and profile steel:
Horizontal cutters. No. 1 and 4
Under cutter. No 1
The cutter working depth is
through the lever pos 211th Locking is
by the handle pos 224.
Normal cutting depth of cutter is 2 mm
Upper cutter. No. 4
The planing thickness is adjusted by a
crank, item 189 the thickness can be
read on the indicator pos 109
on the machine frame. The indicator
can be calibrated. Loosen the green
cap pos 168th The ring above the
indicator has a set screw. Turn the ring
to show the plane height which has
been planed.
Chip thickness up to 8 mm.
Knives under and upper cutter
When the blades has lost its
sharpness, whetstone them. When the
edge has injuries or is not straight,
knives must be grinded.
Always sharpen knives in pairs so that
the knives has the same width,
otherwise vibrations occurs in the
cutter.
Angle of 40 degrees
Before reinstalling and setting the
knives and wedges you must clean
them carefully.
Place the first chip breaker (A) in the
cutter track. Post your knives properly
in relation to the adjustment screws
(C). Note that the grades placed
vertically with the screw head.
Under cutter
Turn down the knives with set screws.
Over cutter
The head of the screw located under
the knives.
Screws (B) of the chip breaker is
drawn hand tight.