WoodMaxx WM-8M, Руководство оператора, Страница: 28 / 58

www.WoodMaxx.com
27
KNIFE CHANGING/ADJUSTING KNIFE CHANGING/ADJUSTING
STEPS:
• Detach PTO shaft from chipper.
[Fig. 1]
• Remove shield that covers drive belts.
• Remove access panel on front and back
of flywheel chamber to expose knife
bolts and nuts.
[Fig. 2]
• Clean and remove any debris that is
impacted in knife bolt allen head socket
using an awl or other pointed object.
Take care to clean these out thoroughly
to ensure allen wrench drive bit seats
properly. If not, you may strip the heads
out. Air blow gun is also helpful.
• Hold the head of the M10 cap screws
with a 6mm allen wrench. From the
back side of the flywheel, with a 17mm
socket remove the nylon lock nuts.
[Fig. 3]
• Remove the knives. Be careful not to
drop the nuts or bolts into the flywheel
chamber. If you do - See
Clearing An
Object From The Flywheel Housing
on page 32.
• Replace knives with new or sharpened
knives.
• Be sure there are no debris between
the knife and flywheel.
Tools you will need:
• Torque Wrench • 16mm Wrench/Socket
• 17mm Socket • 6mm Allen Wrench
Fig 1
Fig 2
Fig 3