www.WoodMaxx.com
21
Un-hook the PTO Shaft from tractor’s output shaft and pull the outer and inner
drivelines apart.
Reattach the outer driveline to the tractor’s output shaft. Pull on the inner and
outer drivelines to be sure they are properly secured.
Hold the inner and outer drivelines parallel to each other:
(3a)
Measure 1” (“B” dimension) back from outer driveline universal joint shield
and make a mark at this location on the inner driveline shield.
(3b)
Measure 1” (“B” dimension) back from the inner driveline universal joint
shield and make a mark at this location on the outer driveline shield.
Remove the drivelines from both the tractor and implement.
Measure from the end of inner shield to the scribed mark (“X” dimension).
Cut off the inner shield at the mark. Cut the same amount off the inner shaft
(“X1” dimension).
Measure from end of outer shield to the scribed mark (“Y” dimension).
Cut off the outer shield at the mark. Cut the same amount off the outer shaft
(“Y1” dimension).
Remove all burrs.
Check the PTO Shaft’s
EXTENDED LENGTH
as described in the next step.
Shortening The PTO Shaft Length
(Refer to Figure 2)
PTO Shaft Shortening - Figure 2
PTO SHAFT SIZING INSTRUCTIONS
PTO SHAFT SIZING INSTRUCTIONS
Содержание WM-8M
Страница 1: ......
Страница 58: ...3 20...