Woodley Clinispin HORIZON 12 Flex, Руководство оператора

Страница: 7 / 16

Woodley Equipment Company – + 44 (0) 1204 669033 – sales@woodleyequipment.com| Page 4
Q
UICK
P
ROGRAMME A
C
YCLE WITHOUT
S
AVING
Time and speed for a cycle can be quickly set without entering the programming mode. While quick, this method
does not allow the cycle to be saved in memory after programming.
If saving or locking the cycle is desired, follow the instructions in the section on Setting or Modifying a Saved Cycle.
The cycle can be programmed by speed (RPM) or g-force (Best practice).
Setting Speed
To change the speed (RPM) shown on the top display, use the up
and down buttons next to that screen. The CYCLE number is
replaced with a “ -- “ in the display, and the top screen displays the
speed.
Setting by G-force
Press and hold the RCF (xg) button while changing the displayed
setting on the top screen, using the up and down buttons next to
it. The RPM will automatically adjust.
Setting Time Press the up and down buttons next to the TIME display.
Change Brake
Values
Enter the Settings mode by pressing the GEAR button.
Press the down key next to the top screen until it shows “Brake”.
To change the value shown on the BRAKE display, use the up and
down buttons next to the BRAKE screen.
Press the GEAR button again to save.
Turn Beeper
On or Off
Enter the Settings mode by pressing the GEAR button.
Press the up and down keys next to the upper screen until
“Beeper” shows on the upper screen. Switch ON or OFF with the
keys next to the lower screen. This setting will apply to all cycles.
Press the GEAR button again to save.