Woodland Mills WC68, Руководство пользователя

Страница: 9 / 32

ASSEMBLY
INFEED CHUTE PANELS CONTINUED…
The round edge bar is designed to add additional strength to the infeed panels and also act
as a rounded edge, eliminating branches from getting caught on the edge of the infeed
panels. To install it, swing the bottom panel up as shown below and fit the tabs of the round
bar on the outside of the panels. and are held in place using five (5) M6 allen key headed
bolts, 13mm lock nuts and flat washers. There are two tabs on the side of the round edge
bar which will be bolted to the side panels in the following step.
The remaining bolts can be installed as shown below to fully secure the panels and round
edge bar in place. Only hand tighten the bolts at this point.
Page of 8 30