ASSEMBLY
PTO SHAFT LENGTH
The chipper is shipped with a PTO shaft that can be fitted to most tractors. The PTO shaft
may need to be trimmed depending on your tractor and configuration. Follow the below
steps to ensure that the PTO shaft is fitted to your tractor correctly.
1) Attach the wood chipper to the tractor, but do not install the PTO shaft.
2) Raise the chipper using the tractors 3 point hitch system so that the shaft on the
tractor is level with the shaft on the chipper.
3) Measure the distance between the locking grooves on the shaft of the tractor and
chipper (
A
) as shown below.
!
4) Measure the distance between the locking pins on the PTO shaft itself when it is in
the compressed/shortest length (
B
) as shown below.
!
5) If (
A
) is at least 1” (25mm) longer than (
B
), the PTO shaft will not need to be cut. It is
recommended that (
B
) not be used at a dimension any longer than 38” (96cm).
6) If dimension (
B
) is longer than (
A
), the PTO shaft will need to be cut. The below
equation may be used to calculate the correct amount to trim.
(B-A) + 1” = C (AMOUNT TO CUT)
7) Once (
C
) has been calculated; this amount will need to be cut off of
BOTH
halves of
the PTO shaft.
8) After both halves of the PTO shaft have been cut, use a file to remove any burrs or
sharp edges and slide the shaft together ensuring it telescopes in and out freely. The
PTO shaft can now be attached to the chipper and tractor, ready for use.
Page
of
11
30
Содержание WC68
