-8-
4.2
INSTALL OF LOOSE PARTS-INTRODUCTION
A few elements will be disassembled from the machine main structure due to packaging and shipping requirements.
These loose parts should be installed as follows.
WARNING
Please tighten all bolts and nuts absolutely. Otherwise, may cause machine wobble or serious injury to the operator or
other persons.
4.1 INSTALLATION ZONE CHARACTERISTICS
WARNING
It is prohibited to install the machine in explosive environments.
The installation zone must be selected evaluating the work space required depending on the dimension of the pieces
to be machined,and taking into account that a free space of at least 800 mm must be left around the machine.It is also
necessary to check The floor capacity and its surface, so that the machine base is evenly resting on its four supports.A
power outlet and a chip-suction system connection shall be closeto the selected machine setting and it must be
conveniently lighted.
4. INSTALLATION AND OPERATION
4.2.1 INSTALL STAND
Tools required for assembly:
-Socket wrench,Exagon socket wrench.
-Put the long beam B onto short beam A align
themounting holes.
- Install A to the bottom of B using eight hexagon screws
1 and eight washers 2.
- Place the material locking assembly C on top of the
short beam and align the mounting hole.
- Mount C onto A (as shown in figure 4.2.1) with eight
hexagonal screws 3, eight washers 2 and eight flat
washers,
- Be sure to tighten all bolts and nuts.
FIG.4.2.1
4.2.2 INSTALL VERTICAL SUPPORT
- Place the vertical support B on the vertical support A,
and align the four mounting holes.
- Install B onto Awith four hexagon screws 1, four washers
2 and four washers 3.
- Insert the gear D into the hole of vertical support A to
cooperate with the guide rack, and fix with flange C.
-Fix the flange C on support A with two hexagonal screws
4.
- Be sure to tighten all bolts and nuts.
FIG.4.2.2
A
B
C
1
2
3
4
A
B
C
D
1
2
3
4
