6. TROUBLE SHOOTING
WARNING
- For any information or problem contact your area dealer or our technical service center. The necessary interventions
must be carried out by specialised technical personel.
- Before carrying out any fault service or maintenance work, please always TRUN OFF THE SWITCH, UNPLUG
POWER CABLE, WAIT FOR SAW BLADE TO COME TO STANDSTILL.
Trouble
Possible Cause
Solution
1.Saw unplugged
1.Check plug connections
2.Fuse blown or circuit breaker tripped 2.Replace fuse or reset circuit breaker
3.Cord damaged
3.Replace cord
1.Warped wood
1.Select another piece of wood
2.Excessive feed rate
2.Reduce feed rate
3.Incorrect blade for cut
3.Change correct type blade
4.Blade tension not set properly
4.Set blade tension according to bladesize
5.Guide bearings not set properly
5.Review guide bearing adjustment
1.Dull blade
1.Replace blade
2.Blade mounted wrong
2.Teeth should point down
3.Gum or pitch on blade
3.Remove blade and clean
4.Incorrect blade for cut
4.Change correct type blade
5.Gum or pitch on table
5.Clean table
1.Extension cord too light or too long 1.Replace with adequate size andlength cord
2.Low shop voltage
2.Connect with local electric company
1.Base on uneven floor
1.Reposition on flat, level surface
2.Bad V-belt
2.Replace V-belt
3.Motor mount is loose
3.Tighten motor mount hardware
4.Loose hardware
4.Tighten hardware
Saw vibrates excessively
Saw makes unsatisfactory cuts
Blade wanders during cut
Saw stops or will not start
Blade does not come up to speed
-11-
