Questions? Call Wood Stone at 800-988-8103
13
October
2005
RFG Oven Installation and Operation Manual
MANTLE MOUNTING
Whether mounting a stainless mantle or a bracket for a granite mantle,
the initial steps are the same.
2. Next, place two spacer
washers on each stud.
4. Lastly, place one final
washer (stainless steel) and
a cap nut on each stud.
Tighten the cap nuts so that
the mantle is securely held
in place.
5. Using the high temperature silicone (provided), fill any gaps between the oven hearth and
the mantle flange. Gaps between the mantle flange and the stainless steel doorway frame
may also need to be filled with a small amount of the silicone compound.
INSTALLATION OF GRANITE - After completing the steps outlined above, apply a generous
amount of silicone adhesive (provided) to the top of the steel mantle bracket.
Put the stone in place and
apply light pressure to seat it
properly. Make sure that the
angle in the granite lines up
with the angle in the bracket.
Allow the adhesive to set for
several hours before filling
any gap between the stone
slab and the metal bracket
with the silicone compound
(provided). Clean up any
adhesive and/or silicone
before it dries!
1. Begin by installing the threaded studs into the
clip nuts below the oven doorway (3 or 4 turns is
sufficient).
3. Position the mantle (or bracket) on the oven,
making sure that the rear flange rests on the floor
of the oven (you may need an extra pair of hands
at this point).
