Wood-mizer TVSE11S - SC, Руководство пользователя

Страница: 48 / 120

Troubleshooting
Setworks Malfunction
4
4-1 TVS_SWdoc031116 Troubleshooting
SECTION 4 TROUBLESHOOTING
4.1 Setworks Malfunction
PROBLEM CAUSE SOLUTION
Setworks does not work. Magnet sensor improperly
adjusted Adjust the magnet sensor as
shown on
Photo 4-1 and Fig. 4-2.
Calibrate the controller. See
Section Auto-calibration.
The controller calcutates
dimensions of boards
incorrectly. Improper input parameters - Check the input divider (See
Section Setting the input divider
(entered only once, at the first
start-up).
- Perform the auto-calibration
procedure.
See Section
Auto-calibration.
During the auto-calibration
procedure, the controller
stops the saw heads and „Err
Call” appears on the display. During the auto-calibration
procedure the limit switch is
activated. Set the head width to 110mm /
(4.33”) before activating the
auto-calibration procedure.
The saw heads do not stop
when the required dimension
is reached, but move inward
or outward until the limit
switches are activated. Setworks not calibrated Check the input divider.
Calibrate the Setworks controller
.
The Setworks stops the saw
heads and „Err P” is
displayed. Incorrect signal of the blades
distance sensor - Check the connections between
the blades distance sensor and the
Setworks.
See Photo 4-3 .
- Make sure the magnetic strip is
not loose.
- Check the connections to the
contactors of the blades distance
setting system.
During manual blades
distance adjustment, the
display shows a negative
blades distance value. Setworks not calibrated Calibrate the Setworks controller .
’’Pur” is shown on the display. If continuously - a loss of
power.
If blinks - the ribbon cable
connecting the controller
boards is broken.
Check the Setworks supply voltage
on the PWR terminals (it should be
12.5VDC).
See Photo 4-4 .
Check the connection between the
controller boards. Make sure the
connector pins are not dirty.
See
Photo 4-5 .