Wood-mizer Titan WB2000-EC, Руководство пользователя

Страница: 33 / 94

Setup & Operation
Setting of operating parameters
EGdoc013119 4-7
4
Trigger – determines the level of power of the main motor, at which a large screen with power reading will be
displayed. This parameter can be used to inform about exceeding the motor power. Such a situation can occur
when hardwood or large logs are cut and the rated power of the motor may be exceeded.
The appearance of the window is presented below:
The window is automatically turned off when the motor power falls below the threshold value set or the CLOSE
button is pressed.
Automatic set – used for enabling the option of automatic setting of the next position when the saw head gets
on the bed to the start of the log position (SOL), which is set with the SOL/EOL (SOL - Start Of the Log, EOL -
End Of the Log) button on the panel. This function will be described in more detail in the "Cutting" section.
Automatic BUMP – used to for enabling the function of automatic raising of the saw head by the value entered
in the BUMP field, when the saw head gets to the end of the log on the bed (EOL). The EOL position is marked
with SOL/EOL button on the panel.
See Section 4.2.8
where you can find the information on how to use this
function.
Automatic return to Start of Log – used for enabling or disabling the function of automatic adjustment of the
saw head speed during its return to the start of the log (SOL) marked with the SOL/EOL button on the panel.
The speed is adjusted to minimize the cases of passing this point. This results in optimization of the cutting time
and requires less attention from the operator during the return to SOL.
If this function is disabled, the operator must decide when to stop the saw head on the bed and adjust its speed.
There are two options available when the automatic return function is turned on:

- Enabled – the saw head moves on the bed with the maximum speed and its speed is decreasing
as it approaches SOL.

- Enabled Potentiometer – the saw head moves with the speed set with the potentiometer and its
speed is decreasing as it approaches SOL. This option is especially useful in the case of large
logs, where a heavy impact of the board removing arm may cause its damage.