SAWMILL ALIGNMENT
Blade Guide Arm Vertical Adjustment
SAWMILL ALIGNMENT
doc092506
5-16
5
5.7
Blade Guide Arm Vertical Adjustment
1.
Move the cutting head so that the blade guide arm is directly over a bed rail.
2.
Adjust the blade guide arm out to within 1/2" (15 mm) of full open.
3.
Measure from the top of the bed rail to the arm.
See Figure 5-15.
4.
Adjust the blade guide arm in to within 1/2" (15 mm) of full closed. Measure again from
the top of the bed rail to the arm.
5.
Adjust the arm so that the measurement from the top of the bed rail to the arm in the
closed position is the same as the measurement from the top of the bed rail to the arm in
the open position.
If the arm is too low in the closed position, loosen the lower outside roller and tighten the
upper outside roller (See punkt 6.)
(See punkt 6.)
6.
The rollers are mounted on cam bolts that raise or lower the arm when turned.
To adjust the rollers, locate the cam bolt inside the housing and turn until the arm is low-
ered or raised as needed. Recheck the arm in both the open and closed positions.
Repeat adjustments until the arm is the same distance from the bed rail in the open and
FIG. 5-15
Turn outside rollers
to raise or lower end
of blade guide arm
20_038
