Blade Support Installation
3-8
WM doc 1/20/21
3
a blade support guide with a blade support post
a blade support guide without a post
two bolts
a flanged hex nylok nut
a wing nut
a blade support wheel
a pushnut ring
Attach a blade support guide to a tube:
NOTE:
The left and right blade guide supports must be assembled with
the post away from the outer end of the support tube.
The rear blade guide support must be assembled with the post closer
to the outer end of the support tube.
See Fig 3-5 and Fig. 3-6
1.
Assemble a blade support guide with a post and a blade support guide without a post
onto the end of a support tube, opposite of the end with the hole for the bolt and nylok
nuts.
2.
Insert the two bolts into the support guide with a post.
NOTE:
The hex-shaped holes will keep the bolts from turning once in
place.
3.
Fasten a flanged nylock nut to the top bolt.
4.
Fasten a wing nut to the bottom bolt.
5.
Slide the blade support guide to the desired position on the support tube.
6.
Tighten the top and bottom bolts, using the flanged nylock nut and wing nut.
7.
Place the blade support wheel over the blade support post.
8.
Place the pushnut ring on top of the wheel to lock it in place.
