Wood master LT 90, Руководство пользователя

Страница: 11 / 32

11
LT 90 Owners Manual 2015
Firing The Furnace
Once properly installed and full of water, go to the E.T.C. control and turn fan switch off. If below “LA” (Low
Alarm, see E.T.C. Section) press set on Dixell. Paper and kindling should be used for starting the fire. Build a
small fire, turn fan switch to on, and close fuel door. Be sure that the pumps are circulating when firing the fur -
nace. Add wood as needed to increase water temperature to 170°F. Once the furnace has reached 170°F, the
furnace is ready to be filled to capacity to operate for a 12 hour period.
Rotate ash from back to front, maintaining a level coal bed. Load wood towards the back of the furnace for
improved efficiency. WoodMaster recommends burning cut, split and seasoned wood. Do not overfill so that
hot coals fall out of the furnace when opening the fuel door. During periods of warmer weather, you may find
it to have creosote inside the firebox. It is important to fill the furnace only with enough wood to last up to a
12 hour period. After burning your furnace for a period of time, you will discover how much wood is needed
per day and what types of wood burn the best.
Loading the Furnace
When loading your furnace the manufacturer recommends that you center your wood lengthwise in one row
as shown below. This will allow air from the draft fan to circulate properly creating the optimum burn
environment.
SIDE VIEW FRONT VIEW
Operation
Note: The amount of wood needed to heat your system will vary depending on a lot of
different factors. System design, insulation values and type of wood are a few of the
contributing factors that will determine how much wood is needed.
Be mindful of the latch on the front door and air holes on rear door when you are stack -
ing the wood.