5
should the A.S.D be altered or bypassed in any way. Only a genuine manufacturers replacement part should be fitted. The individual A.S.D
components are not replaceable.
Note that soft wall coverings (e.g. embossed vinyl, etc.) are easily affected by heat. They may scorch or become discoloured when close to
a heating appliance. Please bear this in mind when installing.
Propane gas appliances must not be installed in a room, which is built entirely below ground level (See BS 5871 Pt2).
TECHNICAL SPECIFICATION
Appliance height:
600mm
Appliance width:
470mm
Appliance depth:
115mm
Height of opening required:
535mm min.
575mm max.
Width of opening required:
335mm min.
435mm max.
Gas
Natural (G20)
Propane (G31)*
Inlet Pressure
20mbar
37mbar
Input - Max. (Gross)
6.0kW (20,500Btu/h)
6.1kW (20,800Btu/h)
Input - Min. (Gross)
2.2kW (7500Btu/h)
3.6kW (12280Btu/h)
Output - Max.
2.5kW (11,900Btu/h)
2.5kW (12,280Btu/h)
Output - Min
0.85kW (3750Btu/h)
0.85kW (6140Btu/h)
Burner Test Pressure (Cold)
17.0±0.75mbar
(6.8±0.3in
w.g.)
36.2±0.75mbar (14.53±0.3in
w.g.)
Gas Connection
8mm pipe
8mm pipe
Burner Injector
Bray Cat. 18 Size 360
Bray Cat. 18 Size 170
Pilot & Atmosphere Sensing
Device
SIT Ref. OP9030
SIT Ref. OPLPG9222
Ignition
Piezo Electric. Integral with
Gas Tap
Piezo Electric. Integral with
Gas Tap
Aeration
Non-adjustable
Non-adjustable
*
When converted using Kit 591149
Clearance to combustible side panels: 100mm
The minimum height from the top surface of the hearth to the underside of any shelf made from wood or other combustible materials is as
follows: -
•
For a shelf up to 150mm deep
Minimum height = 750mm.
•
For a shelf deeper than 150mm
Minimum height = 750mm + 12.5mm for every 25mm depth over 150mm.
PACK CONTENTS
1 Hotbox, and Burner assembly
1 Literature Pack
1
Loose parts pack including:-
1 Front coal Matrix
1 Rear coal Matrix
1 Loose coals Pack
3 Self-Adhesive Foam seals
2 Tension Cables
2 Cable Adjusters
2 Eyescrews
2 Fibre Plugs
1
Strip of Floor Sealing Tape
1 Nut and Olive for 8mm Inlet Pipe
Carefully remove the contents.
Take special care when handling the ceramic components.
Check that all the listed parts are present and in good condition.
