Wonderfire Marseille BR622, Руководство по установке

Страница: 19 / 29

19
11. CERAMIC COALS INSTALLATION
11.1 Place the
ceramic base coal in
the burner
compartment. The
bottom rear face of
the coal should rest on
the angled ledge at the
back of the burner
compartment. The
bottom front recessed
edge of the coal base
should locate against
the step in the burner
plaques (See figure
29).
(Installer - Note that the
small round holes in the
burner plaques which
will be covered by the
base coal are not gas
burner ports. They are
simply a consequence of
the plaque
manufacturing process).
11.2 Place the
ceramic front coal in
position in front of
the base coal. Make
sure that the side
legs of the front coal
are fully seated into
the burner tray.
There will be a gap
between the rear of
the front coal and
the front of the base
coal (See figure 30).
11.3 Install the
13 loose coals as
follows. There are 2
“finger” coals, 7
medium size coals and 4
large coals. Place all the
loose coals so that they
are firmly seated in the
valleys in the coal base
and front coal.
11.3.1 Place the 4 large
coals in the valleys of the
front coal (See figure 31).
11.3.2 Place 3 of the
medium size coals
behind and
approximately midway
between the large coals
as shown in figure 32.
Place a “finger” coal at
each end of the first two
rows of coals. See figure
32.
11.3.3 Place the four
remaining coals in a row
at the back of the firebox
compartment. See figure
33.
Fig. 33 Third Row of Coals
Fig. 31 Front Row of Coals
Fig. 30 Front Coal Location
Fig. 29 Ceramic Base
Installation
Fig. 32 Second Row of
Coals