Wonderfire Marseille BR622, Руководство по установке

Страница: 15 / 29

15
7.1.2.9 Drill a hole into the fireplace floor through each of the two holes in the
base of the convection box. using a no.12 masonry drill (see figure 21).
7.1.2.10 Insert a fibre plug into each hole. Use the rawlplugs supplied with this
appliance - Never use plastic plugs instead of the fibre plugs supplied. Fit a woodscrew
in each plug and tighten.
7.1.2.11 Inspect the fit of the convection box to the fireplace surround. If it is
aligned squarely and the sealing is satisfactory, fully tighten the cable retainers.
7.1.2.12
If the convection box is not correctly aligned, release the tension on the
cables by slackening the screws and turning the hexagonal adjusters fully
anticlockwise. The convection box should then automatically realign itself. Pull
each cable taut again and push the cable retainers back against the “V” brackets.
Again, tighten the screws in the retainers and apply tension to the cables by turning
the hexagonal adjusters clockwise as far as possible.
7.1.2.13 Push the free length of the cables inside the convection box so that they are
available to allow easy removal and refitting of the appliance during subsequent service
calls.
7.2 INSTALLATIONS WITH SPACER KIT 617K
7.2.1 There are 9 indented positions on the front flanges of the convection box. Drill
a 5.5mm hole through each indent (see figure 22).
7.2.2 Place the convection box unit into the installed spacer kit opening. Align the 9
drilled holes with the holes in the spacer unit sides and top.
If a concealed connection is being used, make sure that the supply pipe enters the
convection box through the slit in the rear seal.
7.2.3 Attach the convection box to the spacer unit with the 9 machine screws supplied
with the kit.
7.3 ALL INSTALLATIONS
Important - Seal The Floor Front
Using the floor sealing tape supplied, seal the bottom of the convection box to the
fireplace and hearth floor (see figure 23).
Make sure that the whole length of the front edge of the convection box is fully sealed.
Fig. 23 Floor Sealing
Fig. 22 Spacer Attachment
Points
Fig. 21 Floor Fixing