23
Wolff GmbH & Co KG | D-74360 Ilsfeld | Ungerhalde 1 | Fon: +49 (0)7062-91556-0 | Fax: +49 (0)7062-91556-41 | www.wolff-tools.de
The machine switches off automatically in the event of
overloading.
Overload
The LED flashes in varying intervals.
The machine has been extremely overloaded.
The machine can be restarted after some seconds.
... Electronics
overheated:
The machine can be restarted when the LED stops flas-
hing. This indicates that the electronics have cooled and
the machine is operational.
...Motor
overheated:
The machine can be restarted when the LED stops
flashing. This indicates that the motor has cooled and the
machine is operational To remove load from the machine,
detach the additional weight and/or reduce the speed.
To remove load from the machine, detach the additional
weight and/or reduce the speed.
Fault
Possible cause Remedy
9.0 Disposal information
Disposal
The machine, accessories and packaging should be sorted
for environmental-friendly recycling.
Only for EC countries:
Do not dispose of power tools into household
waste! According the European Guideline
2002/96/EC for Waste Electrical and Electronic
Equipment and its implementation into natio-
nal right, power tools that are no longer usable must be
collected separately and disposed of in an environmentally
correct manner.
Subject to change without notice
10.0 Guarantee
The warranty period for new Wolff machines shall last for
one year from the point at which the machine is transfer-
red / delivered to the customer, insofar as statutory legal
requirements do not stipulate otherwise.
When validating warranty claims, the invoice or proof of
purchase must always be submitted.All repairs within the
framework of the warranty agreement must be undertaken
by a service Centre that has been accredited by us.
Customers performing their own repairs and/or improper
repairs regularly lead to the exclusion of warranty claims.
The same also applies to incorrect operation and/or use.
Replacement of parts, accessories and other modifica
-
tions to Wolff machines
Users of Wolff machines enjoy a high level of safety and
reliability of their machine. In order to maintain this status
quo, your Wolff tool may not be modified from the condition
in which it is delivered without following the rules below.
These rules apply to both the replacement of parts and
equipping the machine with accessories as well as other
technical modifications.
All work undertaken to your Wolff machine must be
The machine
does not start
Power interrupted
Fuse defective
Cable defective
Plug defective
Contact Electrici-
an. For repair and
/or replace parts
The machine
does not start
Safety switch
allows the lever to
be operated only
when the handle
is tilted
Tilt the handle of
the machine
The machine
does not start
Overload of the
machine
Remove ad-
ditional weight,
work with lowered
running gear, see
section 3.5 Setting
the running gear
The machine
does not start
Overload of the
machine
Tilt the machine
over the running
gear, the load on
the plate is relie-
ved. Switch on the
machine, lower
slowly
EN
