Wolf SO30F/S, Руководство по конструкции

Страница: 21 / 120

Wolf Convection Steam Oven
21
wolfappliance.com/specs
Planning Information
The convection steam oven can be installed with or
without side trim in a standard or flush inset application.
A minimum base support of 100 lbs
(45 kg)
is required.
The electrical supply for the oven must be located in an
adjacent cabinet.
STANDARD INSTALLATION
For standard installations, the convection steam oven is
installed by inserting into cabinetry from the front. The
oven has face trim on the top and both sides that will
overlap stiles and rails. Refer to the chart below for trim
overlaps.
FLUSH INSET INSTALLATION
For flush inset installations, a minimum
1
/
8
"
(3)
reveal is
required on all four sides. The inside edges of the rough
opening must be finished, as they will be exposed when
the oven door is open. These edges should be stained
instead of having a laminated surface, to avoid damage
from high temperatures and steam.
COMBINATION INSTALLATIONS
The Wolf convection steam oven with trim is designed
and agency approved for installation with Wolf cooktops,
built-in ovens, microwaves and warming drawers only.
If it is being installed above or below an E series oven in a
flush inset application, a
1
/
4
"
(6)
reveal is required.
ELECTRICAL REQUIREMENTS
Electrical Requirements
CONVECTION STEAM OVEN
Electrical Supply 240/208 V AC, 60 Hz
Service 20 amp dedicated circuit
Receptacle NEMA 6-20R grounding-type
Power Cord 6'
(1.8)
Oven Trim Overlap
OVEN TRIM
Top Overlap
3
/
16
"
(5)
Bottom Overlap 0"
(0)
Side Overlap (without trim)
5
/
8
"
(16)
Side Overlap (with trim) 3
13
/
16
"
(97)