wolfappliance.com
|
7
Preparation
Before moving the range, protect any finished flooring and
secure oven door(s) closed to prevent damage.
To lighten the load or to fit through a door way, the oven
door(s) can be removed. Only remove if necessary. Do not
remove griddle or any other component. Door removal
should only be done by a certified installer or service
technician.
For removal, a hinge pin will be inserted into the appropriate
hinge shown in the illustrations below. The pin(s) are located
inside the oven door. For single oven ranges, the hinge pin
must be inserted in the right hinge. For double oven ranges,
the pins must be placed in the outer two hinges.
CAUTION
Failure to insert the hinge pin in the appropriate hinge
arm will cause damage to the range.
INSTALLATION
OVEN DOOR REMOVAL
1
Insert the hinge pin into the appropriate hinge.
2
Remove the lower kickplate assembly to access the
lower hinge retainer mounting screws.
3
Open the oven door and remove both upper and lower
hinge retainer mounting screws. The oven gasket may
have to be moved slightly to access the bottom screws.
4
Move the hinge retainer plate forward slightly. The hinge
retainer plate will remain on the door hinge after the
mounting screws have been removed.
5
Carefully close the oven door to approximately 60°, then
lift the door up and out. A slight rocking motion may be
required for removal.
KICKPLATE
UPPER
MOUNTING
SCREW
HINGE
RETAINER
PLATE
HINGE
PIN
Oven door removal.
SPRING HINGES
SPRING HINGE
SPRING HINGES
SPRING HINGE
Single oven ranges.
Double oven ranges.
