15
Disarm
It means to stop the alarm when the main unit sounds the alarm or make
the alarm system in the state of non-warning. After disarming, even if you
trigger the detector, the main unit would not sound alarm (excluding
24-hour defense areas).
Use keypad to input system password, then press [
#
] button. [
Out Home
]
or [
At Home
] lights will be off. It means set system disarm successfully.
Remote Control Operation: Press [
] button on remote controller
Main Unit Operation: input system pa [
#
]
LCD display:
Answer Alarm Call
When the main unit sounds alarm, it will dial the preset numbers. If no
one answers the call, the system will call the next user number
automatically. The system will call each preset numbers for 3 times in
order.
If you answer the call, you will hear the pre-record voice. You can set
system via your telephone or mobile phone keypad.
If you hang-up directly without answering the call, the system will call
each preset number for 3 times circularly.
Press [*]
: Read the alarm information.
Press [1]
: Main unit stops alarming and Arm; it stops calling users.
Press [2]
: Main unit stops alarming and Disarm; it stops calling users.
Press [3]
: Siren off and monitors the scene for 30 seconds; for continued
monitoring, press [3] again to monitor for another 30
seconds.
Press [4]
: Main unit starts a 30-second two-way intercom. During this
time, the main unit cannot be controlled by the mobile until
16
30 seconds later.
Remote Control
Dial the number associated to the alarm main unit by phone (mobile
phone), and after one ringing cycle, you can hear a voice prompt “Please
enter password”. If the password is right, you will here “Press 1 to arm,
Press 2 to disarm, Press 3 to Monitor, Press 4 to Intercom”. If the
password is wrong, you will hear a prompt voice “wrong password,
please re-enter”.
Press [1]
: arm, if finished successfully, you will hear a voice prompt
“System armed”.
Press [2]
: disarm, if finished successfully, you will hear a voice prompt
“System disarmed”.
Press [3]
: monitoring for 30 seconds, to continue monitoring, press [3]
again to monitor for another 30 seconds.
Press [4]
: two-way intercom for 30 seconds. You can’t operate the main
unit during this time.
Emergency Help
Press [Emergency
] button on keypad, or [
] button on remote
controller or wireless panic button, the main unit will alarm and make call
to the preset user numbers.
System Dialing Function
In disarm status; you can use the main unit to make any call just like a
land-line telephone. Dial telephone number on keypad, press [
] button,
the main unit will make a beep and the [
Signal
] indicator will be flashing.
After the call, press [
] button again, the main unit will be in disarm
status.
Alarming Record Checking
In disarm state, input [*0#], then the main unit will make a long beep and
enters the state of alarm record checking. After displaying the alarm and
defense zone number indicator, the LCD screen will display the exact
alarming time of this defense zone. Press 2, you can upturn to check the
