5
LCD display:
Function Settings
Initialization
Please insert SIM card and plug in power adaptor, and then power on the
system, all the LED lights will be on for 2 seconds and you will hear a
long beep; the system comes into initialization. After the time clock
displays on the LCD screen, the [
SGM
]
starts flashing and the main unit
starts to detect the GSM network until a long beep. Then the [
SGM
]
indicator goes out indicating the system comes into disarm status.
Finally, turn on the backup battery switch.
Enter Settings
In the state of disarm, input 4-digit password by the keypad on the main
unit and press [
#
] button to confirm. You will hear a voice prompt: please
enter instruction. At the same time, [
SET
] indicator is on without flashing
and [0000] displays on the screen, indicating the system enters setting
status. You can perform different settings repeatedly as long as the system
keeps in setting status. The system will exit setting mode and return to
disarm status if you don’t press any keypad button for 40 seconds.
Note
˖
˖
In setting status
ˈ
press
can delete the numbers input
The system default password is [8888]
.
Operating method: [
XXXX
]
Ö
[
#
]
6
X
indicates the new 4-digit password.
LCD display:
Exit Settings
Press [
*
] and [
#
] buttons, the main unit emits a long beep and exits
settings. The [
SET
] indicator goes out and the system returns to disarm
state.
Operating method:
Ǐǐ
Ö
Ǐ
#
ǐ@
Factory Reset
In disarm status, use keypad to input [
95175308246
] and press [
#
] to
confirm, all the LED indicators will be on for 2 seconds and you will
hear a long beep. The main unit gets all its settings cleared and restores
to its factory settings successfully.
Operating method: [
95175308246
] + [
#
]
Coding of Remote Controller
The remote controller has to be code to the alarm host in order to
perform normally.
In setup state, use keypad to input [
20
], input the remote controller
number [
1~8
], and then press [
#
] to confirm. The main unit emits a long
beep and you will hear “remote control coding”. The [ ] indicator is
on without flashing; press any button on the wireless remote controller,
the main unit makes a long beep and you will hear “coding completed”,
[ ] indicator goes out, indicating the remote controller succeeds in
coding.
Operating method: [
20
]
Ö
[
A
]
Ö
[
#
]
A
indicates
˖
1~8 remote controllers number. You can add maximum 8
remote controllers.
LCD display:
`