Establish a USB connection between the PC and the router with a micro-USB cable
connected to the socket marked
USB
. (The driver must be installed on the PC according
to the
Installation Guide
).
Set the IP address of the
USB-Ethernet interface
on the PC for the “
USB Ethernet /
RNDIS Gadget
” network connection (
Control Panel / Network / Network Adapter /
Adapter Settings
). You can also voltage the device on the
USB
connection at the IP
address.
To connect to the website, enable access to the router's IP address in the browser (from
the computer on the USB network interface it should always appear as
192.168.10.10
IP
address, Subnet mask: 255.255.255.0 - this is set in
Control Panel / Network and Sharing
Center / Adapter Settings / Under Network Connections
, to the
USB Ethernet / RNDIS
Gadget Interface
.)
If the router is not starting
It is possible that there is no uploaded software available on the router. Upload the
router software or ask our support line!
Periodic restart of the router (by 10 minutes periods)
When router was not be configured properly for the ppp/wan connection or the modem
was not started then the router will be restarted within in 10 minutes.
You can also configure the periodic ping interval from the LuCi / OpenWrt.
Restart of the router
If the router is not responding permanently, you can restart it by disconnecting power
cable (
POWER
titled microfit connector) then after a few second plug it again. The LEDs
must assign the presence of the power source.
Shutdown / halt the router
To shutdown the router, first you have to reboot by the
System / Reboot
menu. When
all the three LEDs blinks at once, the router is restarted and can be switched off safely
as soon as you can
–
pull out the power connector from electricity plug.
Attention! Never stop the router without requesting the reboot process, and do not
remove the power socket without restarting the router before this action!