Blatt/
sheet
D729MGB.010
Datum/
date
23.05.2007
Stand/
version G-07.05.2018
Geprüft/
approved WAT/MZE
Änderungen vorbehalten!
Subject to change without notice!
Progressive Safety Gear
USG-25P
Operating Instructions
3.1.1
Mounting with Flat bars
(integrated solution)
Demands:
•
rectangular cut out
(e.g. in upright) of
minimum WxH = 165x135mm
•
fixing holes ø12,5mm (for M12 screws) with
a height distance tol0/-0,5mm
For details refer also to catalogue
D700CDEGB.1.9
Mounting:
(
1
) Mount upper flat bar (10mm thick material)
(
2
) Put in the safety gear (from back throuch the
cut out) and secure with lower falt bar
(
3
) Hang in the reset spring (spring force
F1=35-40N, spring rate ~1,4N/mm)
and mount the reset limiter screw (M8)
Ensure correct alignment to guide rail (see
chapter 3.2)
Note: the tightening momentum for M12
is 80Nm
Note: the tightening momentum for M8 is
10-13Nm
(
4
) Repeat this sequence on the other safety gear
