Wisenet QRN-1630S, Быстрое руководство

Страница: 4 / 14

4
Installation Wizard Setup
As shown below, proceed through each step of the <
Installation wizard
>. Install Wizard can only be accessed at
factory reset. If you do not want to proceed, click <
Exit
>.
■
You can set the install wizard on the recorder and web viewer. Refer to the User Manual for instructions on how to set up the install wizard on the
web viewer.
■
When you complete installation using the install wizard on your recorder, the install wizard will not appear on your web viewer.
1
Select the language
Select your preferred language.
2
Network Settings
●
DHCP server : If the DHCP server is set to enable, an IP is automatically assigned to the camera.
●
Network 1 (Camera) : Port for camera connections; it receives video from a camera.
●
Network 2 (All) : Network for a remote viewer (SSM, Smart Viewer, Webviewer)
●
Network 1 (Camera) / Network 2 (All) Setup
– IP Type : Choose the network connection method.
– IP Address, Subnet Mask, Gateway, DNS
●
Camera registration method : This function is only available for products that support PoE. For products that
support PoE, see “
Products supporting each feature ” (Page 4) in the Product Specification Manual.
– Enable PnP mode: Cameras connected to the PoE port of the product will automatically be registered for
each channel in order of port number.
■
When the camera resets to factory default, it defaults to the ID and password set during the < Camera ID/PW > step.
■
If the camera’s ID and password have already been set, the information that matches the ID and password set during the < Camera
ID/PW > step will be registered (up to 3 sets).
If your camera uses a manual IP, its bandwidth should match with that of Network 1 IP for registration.
■
If the PnP mode is not used, automatically detects and registers camera connected to the product’s PoE port and camera with
separate switch.
●
Enable online upgrade
– You can receive a new firmware notification when your device is connected to a network.
※
For more details on network settings, refer to the User manual.
▶
To use a simple intranet, click < Next >.
QRN-830S
1 Loosen the screws on the back and slide the
cover back to remove it.
2 Connect the SATA/power cable of the hard disk to
the connector of the main board.
■
Gently press the connector before removing the HDD. Do
not force to pull the cable.
3 Use the screws to fix the hard disk to the bottom
of the recorder.
4 Make sure that there is no problem in the
connection port and routing inside the recorder,
and then fix it using screws after closing the cover.
■
When closing the cover, be careful not to damage the cable.