WireTech 5000P-10x, Руководство пользователя

Страница: 11 / 28

LOCK indicator on front panel will turn green.
LNB Frequency: Input LNB frequency
Satellite Frequency: Input downstream frequency of satellite
Symbol Rate: Input symbol rate of satellite
LNB Voltage: select the correct LNB voltage output of the F-connector: Off, 13 V, 18 V. <A>
LNB 22KHz: activate the LNB 22 kHz control signal to the LNB: On or Off. <B>
DISQEC: Can select OFF/Port A/Port B/Port C/Port D
Note: please contact the local satellite operator for the satellite frequency and symbol rate.
<A> Normally, 13V switches the LNB to receive Vertical/Left hand polarization
while 18V receive Horizontal/Right hand.
<B> Normally, 22KHz control signal switches the LNB to receive high band if any.
5.1.3 RSSI
There are two options to show the quality of receiving DVB-S2 signal.
5.1.4 Ethernet Menu
(The Ethernet menu is showed only if the IP streaming in/out board is installed and the
TS/IP streaming
board is set to “IP IN”. Refer to section 5.3.6.)
The Ethernet connector is for receiving transport stream over IP. The Ethernet
connector has user-configurable IP address, network mask and default gateway. These must
be set to appropriate values for the network over which the transport stream over IP is
received.
Stream IP Addr: Enter the IP address for streaming IP input of the unit.
Stream Netmask: Enter the network sub mask for the subnet to which the unit is
connected for IP streaming traffic.
Stream Gateway: Set the gateway for the network to which the unit is connected
for IP streaming traffic.
Stream Mac Address: factory-set MAC addresses are guaranteed to be unique.
Therefore you cannot configure the address.
Multicast IP Addr: Enter the IP address of the multicast stream for the transport
stream over IP.
Multicase UDP Port: Enter the UDP port number of the TS over IP stream.
Protocol: select the protocol for multicast: UDP or RTP.
Output Smoothing: set the quality of TS which comes from the TS/IP input.
Auto : the bit rate is variable.
Disable : the unit let the TS pass by.
Fixed Rate : the bit rate is fixed.
TS Bit Rate: set the bit rate of the TS comes from the TS/IP input. The setting is