Wintriss SmartPAC PRO, Руководство пользователя

Страница: 62 / 318

1143100 SmartPAC PRO User Manual
62 Chapter 2 – Installing SmartPAC PRO
7. Verify that you have installed the board(s) properly by performing the procedure in Zeroing the
Resolver , page 75. You need to complete this procedure before you can use SmartPAC PRO.
Connecting DiPro Sensor Interface to SmartPAC PRO
NOTICE
For information about using the DiProPAC, see Chapter 6
– Using DiProPAC Die Protection
(Optional), page 159
To connect your DiPro die protection sensors through the DiPro Sensor Interface (DSI) 2, refer to
•
Table 2-4 to wire sensors 1-8
•
Table 2-5 to wire sensors 9-16
•
Table 2-6 to wire sensors 17-24
•
Table 2-7 to wire sensors 25-32.
Refer to wiring diagrams at the end of the manual (Figure 1 for sensors 1-16, Figure 2 for sensors 17-
32). Refer to the DSI 2 manual for more information.
Terminate cable shields as close as possible to the terminal blocks, either beneath a screw on a
standoff or to a ground stud, as described in
Terminating Cable Shields , page 46.
Figure 2-12. DiProPAC Boards (8-, 16-, and 32-Sensor): Location of Components