Wintriss SmartPAC 2, Руководство пользователя

Страница: 386 / 604

1128600 SmartPAC 2 with WPC 2000 Integration User Manual
7-24 Fault Messages
“Strokes counter preset reached”
Problem:
The value set for the strokes counter has been reached. The press should stop at
top dead center.
Remedy:
Press RESET to clear the message. If your part run is complete, you need to
change tooling, material, etc. before you re-start the press.
“Batch # counter preset reached”
Problem:
The value set for one of the three batch counters when the output type is set to TOP
STOP has been reached. The press should stop at top dead center. See
Setting
Batch Counter Output and Increment Modes
, page 5-13.
Remedy:
Press RESET to clear the message.
Messages for Equipment or Brake Monitor Problems
The following messages cover resolver and input circuit faults, problems with the way the
press is running, brake monitor faults, and internal problems with SmartPAC 2.
“Loss of rotation detected”
Problem:
The resolver did not start rotating within the start time limit set in Initialization
(see page 4-31) or stopped rotating while the press was running.
SmartPAC 2 knows when the Dual Safety Valve (DSV) is energized. If it sees that
the DSV is energized but the resolver is not turning, this message appears.
One possible cause is that the resolver’s drive belt is loose or broken. Another is
that you may have low air pressure to the clutch or a bad clutch. An internal
SmartPAC 2 problem could also have occurred, or the resolver could be defective.
Remedy:
Check the resolver, the resolver drive, and the clutch. Repair if necessary. If these
solutions do not work, an internal problem may have occurred. Call Wintriss
Tech. Support.
When this message appears, the strokes count is automatically reset to 0.
When this message appears, the corresponding batch count is automatically reset to 0.
NOTICE
NOTICE