2. Press the or key to select the
CONFIGURE
in the LCD menu, and then press
the OK key.
3. Press the or key to select the
LIGHT
in the LCD menu, then press the
OK
key.
4. Press the or key to change to the
ON
or
OFF
mode.
5. Press the OK key to save setting and LCD shows
SUCCESS
then exit to current
setup state, You can press any device key to finish set up or press the
EXIT
key to
last state, or you can use or to select other set up.
E.
Contrast Adjust
If you are not satisfied the screen contrast of your remote control, you can use below
steps to change it.
1. Press and hold the
SET
key for more than 3 seconds, then release it.
2. Press the or key to select the
CONFIGURE
in the LCD menu, then press the
OK
key.
3. Press the or key to select the
CONTRAST
in the LCD menu, then press the
OK
key.
4. Press the or key to adjust contrast level, and then press the
OK
key when you
satisfied.
5. Press the OK key to save the setting and the LCD shows
SUCCESS
then exit to
current setup state. You can press any device key to finish set up or press the
EXIT
key to
last state, or you can use or to select other set up.
F. Show View Function
SY004 has a
Show view
f
unction to scan all TV or CAB/SAT channels for your quick
view.
1. Press the device key to select the device (such as TV) that you want to operate.
2. Press and hold the Show View key about 1 second. When the device's LED flashes
and it goes into Show View mode. The remote control automatically scans all channels for
a brief quick view.
Remark: 1. The remote control must be pointed at the device until Show View
mode finished.
2. If you want to exit the show view mode, please press any key.
G. ALL OFF
You can turn on or off all devices by this button.
Press and hold the
ALL OFF
key about 1 second and then release them. The remote
control will send out all current power signal to turn on(or turn off) for every device one
by one. Meanwhile the device key flashes to tell you which power signal is been sending.
14
Other Set-up