WinSystems PPC65-1210S, Руководство по эксплуатации продукта

Страница: 56 / 79

110912 PRODUCT MANUAL PPC65 56
IDE HDD Block Mode
If the IDE hard drive supports block mode, select Enabled for automatic detection of the optimal number of block read/
writes per sector the drive can support.
Selection Options: Enabled, Disabled
IDE DMA transfer access
Selection Options: Enabled, Disabled
On-Chip Primary/ Secondary PCI IDE
The chipset contains a PCI IDE interface with support for two IDE channels. Select Enabled to activate the primary IDE
interface. Select Disabled to deactivate this interface.
Selection Options: Enabled, Disabled
IDE Primary/Secondary Master/Slave PIO
The four IDE PIO (Programmed Input/Output) fields allow users to set a PIO mode (0-4) for each of the four IDE devices
the on-board IDE interface supports. Modes 0 through 4 provide successively increased performance. In Auto mode, the
system automatically determines the best mode for each device.
Selection Options: Auto, Mode 0, Mode 1, Mode 2, Mode , Mode 4
IDE Primary/Secondary Master/Slave UDMA
Ultra DMA//66/100 implementation is possible only if the IDE hard drive supports and the operating environment
includes a DMA driver (Windows 95 OSR2 or a third-party IDE bus master driver). If your hard drive and system software
both support Ultra DMA//66/100, select Auto to enable BIOS support.
Selection Options: Auto, Disabled
On-Chip Serial ATA
[Disabled]: Disabled SATA Controller. [Combined Mode]: PATA and SATA are combined. A maximum of 2 IDE drives in
each channel. [Enhanced Mode]: Enable both SATA and PATA. A maximum of 4 IDE drives are supported. [SATA only]:
Only enable SATA.
Selection Options: Disabled, Auto, Combined Mode, Enhanced Mode, SATA Only
PATA IDE Mode
Selection Options: Secondary
On-board Device