10
To install the VideumCam Traveler hardware on your laptop
computer, follow these steps:
1. Turn on your laptop computer and close any open
applications.
2. Insert the Videum CD into the CD-ROM drive.
3. Attach the camera to the laptop clip-on base.
4. Place the camera assembly on
top of the laptop flat panel
5. Connect one end of the cable
to the camera, if the cable is
not permanently attached.
The green light on the front of
the camera indicates that the camera is on and initialized.
The light is only on when the Videum software is running.
6. Open the PC Card slot cover on the side of your compu-
ter and insert the PC Card into the PC Card slot as
shown. Then connect the cable to the PC Card.
Hold the PC Card at the edges and align the card with the
connector slot. Firmly press the card into the connector
until the release pin is pushed out.
Windows detects the new hardware and asks if you want to
install the appropriate drivers. Proceed with the driver
installation. You should hear a two-tone beep indicating that
the card is properly installed in the slot.
VideumCam Traveler
