Winnebago Sunflyer, Руководство пользователя

Страница: 87 / 144

7-7
SECTION 7
PLUMBING SYSTEMS
4. Close sewage valve and open waste (grey)
water dump valve with a quick pull. Close
valve handle as soon as tank is empty.
5. After both tanks have been drained, run sev-
eral gallons of water into the sewage tank
through the toilet. Then open sewage dump
valve and drain the tank again. Close valve
when done.
6. Close hose valve by pulling handle up until
lock snaps into place.
7. Rinse end of sewer hose thoroughly with
water and stow.
8. It is advisable to add an odor control chemi-
cal to the sewage holding tank. These chemi-
cals are available at most R.V. stores.
NOTE: We recommend that you dump all hold-
ing tanks before traveling to avoid carry-
ing unnecessary weight.
Flushing your Black Water Holding
Tank
The black water holding tank is equipped
with an internal flushing head to allow you to
rinse the inside of the tank with clean water after
dumping.
1. Dump your black water holding tank in the
usual manner at approved sewage disposal
station.
2. Leave black water dump valve open while
flushing tank.
3. Attach a garden hose from a city water
hydrant to the Flushing System fitting near
the black water dump valve. (This inlet is
clearly marked separate from the City Water
inlet.)
4. Turn the water on to begin flushing; allow
water to run for about three minutes.
5. Disconnect hose from flushing system fitting
and close dump valves.
USING ON-SITE SEWER HOOK-UPS
The drain hose may remain attached to the
dump outlet and be routed out the bottom of the
compartment while the motor home is parked and
connected to an on-site sewage hook-up.
When using a sewer hook-up, keep the dump
valves closed until a tank becomes full or when
preparing to leave the site. This keeps the solids
in suspension, allowing them to be carried out
with the liquids when the dump valve is opened.
Holding Tank Valves (Typical)
Black Water Tank
Flush Fitting