Winnebago Sunflyer, Руководство пользователя

Страница: 103 / 144

8-13
SECTION 8
APPLIANCES & INTERIOR FEATURES
NOTE: If heat does not come out of the heat
ducts after a minute or so the burner is
not lit. Turn thermostat off for 3-5 min-
utes, check to be sure tank valve is open
and tank is not out of fuel, then try steps
2-4 again. If it still will not light after
three attempts, go to Shut Down steps
and contact your dealer or a local RV
service center.
To Shut Down:
1. Slide thermostat/system switch OFF.
2. Close LP tank valve.
For Further Information
Please see the Suburban furnace operating
instructions provided in your Owners InfoCase
for further information, including operating pre-
cautions, and periodic maintenance.
ELECTRONIC THERMOSTAT
(Central Heat/Air Conditioning System Only)
The thermostat, located in the galley area,
controls heating, air conditioning and cooling fan
features.
NOTE: The thermostat does not automatically
switch between heating and cooling. You
must place the switch in the desired posi-
tion.
Heating:
• Slide the thermostat switch to “Heat” posi-
tion.
NOTE: Follow proper furnace lighting proce-
dures described previously in this sec-
tion.
NOTE: If your coach is equipped with the
optional electric Heat Pump, be sure the
Thermostat switch is in Gas Heat posi-
tion. See Heat Pump for details.
• Adjust the temperature setpoint to personal
preference if needed. See “Set Temperature”
below.
Digital Thermostat Display
The digital display normally shows current
room temperature, with the word “ROOM” in
small letters at the left side of the display. When
you press the temperature selector button up or
down, the display will show the word “SET” and
the new temperature setpoint until you release
the button.
Set Temperature
To set the temperature to a new temperature,
simply press the Temperature Selector button up
or down until the temperature you want appears
in the display. The word “SET” will also appear
at the left side of the display while you are
changing the temperature setpoint. A few sec-
onds after you release the temperature selector
button, the display will return to showing the
current room temperature.
Cooling (A/C):
• Slide the thermostat switch to Cool position.
• Slide the Fan Mode and Fan Speed Switches
to the desired positions.
Temp Selector
Heat Source Switch
ELECTRIC = Heat Pump
GAS = Furnace