8-11
SECTION 8
APPLIANCES & INTERIOR FEATURES
The dinette/bed is now ready for use.
Reverse the above procedure to change bed
back to dinette.
COMPANION SEAT/BED CONVERSION:
Model 22QD only
To convert the passenger companion seats
into a bed:
1. Lift up on the seat release lever at the front
of the seat.
2. Lift back edge of seat cushion and swing seat
cushion up and forward. Remove center bed
cushion from storage location beneath seat,
then swing seat cushion back down.
3. NOTE: Headrest must be removed from left
(driver seat) companion seat before convert-
ing to bed. Pull upward evenly on both sides
of headrest to slide out of sockets. Replace
headrests onto seats when returning seats to
upright position.
4. Lift the front of seat upward and pull for-
ward. At the same time, push the back of the
seat down so the entire seat assembly lies
flat.
5. Repeat above steps for other seat.
6. Insert side support pegs of one center cush-
ion into hooks beneath the front aisle side of
the seats. (Center cushions are interchange-
able and can be used in either front center or
rear center positions.)
7. Pull “T” supports outward from sides of
seats as shown. Swing center cushion down
to rest on “T” supports.
8. Rest pegs of remaining cushion into notches
at rear frame. Fold armrest down and lower
cushion onto “T” supports. Raise armrests
straight upward to install rear cushion, then
lower armrests flush with cushion.
Reverse procedure to convert back to seating.
1.Pull Up
2. Slide
Outward
3. Repeat for
Other Seat
FRONT
OF
VEHICLE
2
2
1
2
2
4
3
6
7
8