8-9
SECTION 8
APPLIANCES & INTERIOR FEATURES
Rotating Antenna
- Make sure antenna is in
the “UP” position. Pull down on rotating knob
until it disengages ceiling plate and rotate for best
picture and sound on TV set.
Lowering Antenna to Travel Position
- Ro-
tate antenna until pointer on rotating knob aligns
with pointer on ceiling plate.
Turn elevating crank (counterclockwise) in
“DOWN” direction until resistance is noted. An-
tenna is now locked in travel position. Turn am-
plifier power switch “OFF”.
Count the number of turns needed to crank the
antenna down to the roof of the unit (normally
about 13). Mark the final position of the crank
handle on the ceiling or the directional knob for
reference. Also mark the number of turns needed.
Use the mark and number as a reference whenev-
er you lower the antenna.
SIGNAL AMPLIFIER
To operate the antenna signal amplifier, turn
on power switch.
The amplifier power switch is located on the
main TV jack plate.
Model 22FD/Twin:
The TV jack plate is located
on the left hand side of the center night stand.
Model 22FD/Queen:
The TV jack plate is
located on the rear side of the vanity cabinet.
Model 22QD:
The TV jack plate is located
on the right hand underside of rear overhead
cabinet.
Model 22HD:
The TV jack plate is located on
the front end of right hand rear overhead.
Checking Performance
To check the antenna amplifier, raise the an-
tenna, select a TV channel and rotate the antenna
for best picture. Then turn off the amplifier pow-
er switch. If the antenna amplifier is working
properly, the TV picture will now be degraded
(snowy). When you turn the switch back on, the
picture should again be sharp.
The TV signals available to an RV are entirely
dependent on its location in relation to the trans-
mitter. Signals may vary from strong to no usable
signal at all. We recommend that the TV system
be checked out in an area known to have good TV
reception.
CAUTION
Never leave the antenna partially
raised or partially lowered. This can
damage the crank mechanism gears.
Always raise the antenna straight up
or lower it completely into the travel
position.
CAUTION
Always align directional handle to
“DOWN” position before lowering.
12-volt
Power
Jack
Antenna
Amplifier
Switch
Power On
Indicator
TV
Jack