5-3
SECTION 5 –
ELECTRICAL
The inverter converts 12-volt DC current from
the house batteries into 120-volt AC current for
use by 120-volt AC equipment in the motorhome.
Charging Section
While connected to 120-volt external power,
the inverter/charger will recharge the house
batteries using a 3-stage battery charger. It will
also supply 12-volt DC current for use by 12-volt
equipment in the motorhome.
If the house batteries have been significantly
discharged, they will accept charge at a relatively
high amperage rate. If they are only slightly
discharged, they will charge at a lower amperage
rate. The rate of charge will decrease as the
batteries reach full charge, then will continue
“trickle” charging at a very low amperage rate.
If the batteries do not charge as described
above, it is possible the batteries are defective. If
the batteries are extremely discharged, the
charger may not be able to recharge the batteries.
NOTE: Do not leave the shoreline plugged in
during storage. Follow regular battery
inspection and maintenance.
Inverter/Charger Control Panel
The inverter/charger has a wall-mounted
control panel that can be programmed for several
charging options. It will also display warnings for
overload conditions or other operating failure
conditions.
The inverter/charger control panel is located
near the monitor panel or near the slideout
control switches, depending on model.
When the inverter/charger is not being used, it
should be shut off at the charger panel. The
inverter/charger could drain the house batteries if
the shoreline is not connected to external power
and the inverter/charger disconnect switch is on.
NOTICE
Do not store items too closely around the
inverter unit in the storage compartment.
The inverter generates heat while
operating and needs unrestricted airflow
for proper cooling. Damage to the inverter
can result.
Inverter Charger Unit
(Accessible through the driver’s side
battery access compartment)
-Typical View