10-3
SECTION 10 –
SLIDEOUT ROOMS
•
Press the Slideout Room “RETRACT/IN”
switch and hold until the room is fully
retracted, then release the switch.
•
To stop retracting the room during operation,
release the button.
•
After the room is retracted, Remove and
Secure the Ignition Key.
SLIDEOUT ROOM – EXTREME
WEATHER PRECAUTION
Certain extreme weather conditions, such as
heavy rains, heavy snow, and high winds, or any
combination of these, could cause damage to the
slideout room cover-awning (if equipped) or
reduce effectiveness of the slideout room weather
seals.
Also, freezing rain and snow can prevent the
slideout cover-awning (if equipped) from closing
and may cause damage to the cover-awning,
slideout room, weather seals, and mechanisms.
To avoid potential damage, we recommend
retracting your slideout room during extreme
weather conditions.
SLIDEOUT ROOM
TROUBLESHOOTING
(LIPPERT)
–If Equipped
Battery Voltage or Circuit Breaker
Problems
If the slideout room will not work:
•
Turn the House/Coach Battery Disconnect
switch OFF and then ON again. This will, in
many cases, reset power to the slideout
system.
•
he chassis battery may be low on charge.
Press and Hold the Battery Boost switch
(located on the dash) while pressing the
interior slideout control switch. This
momentarily connects the house batteries to
assist in slideout room operation.
•
The circuit breaker may be tripped. The
circuit breaker, labeled “Slideout Power” is
located on a panel on an interior wall of the
passenger side storage compartment just
behind or ahead of the entrance door.
Slideout Cover-Awning
-Typical View
Slideout Room Controller
(Located in a driver or passenger side
compartment, depending on model)
- Remove panel to access
•Status
LED’s
•Motor
Direction
•Mode
Button
•Motor 1
Connection
•Motor 2
Connection
