10-5
SECTION 10
SLIDEOUT
10 SLIDEOUT
Type B - Single Arm
-
cover mounted beneath
face of slideout room: Remove the four bolts that
fasten the cover to the arm - two on each side.
The crank socket is shown in photo 3.
Insert the crank handle into the socket and
align the notches in the crank handle with the
pins on the drive shaft as shown in photo 3.
It may be necessary to move the handle
slightly from side to side to fit it onto the shaft.
The crank handle will only move the arm that it
is inserted into. Consequently you will need to
alternate between each crank handle on each side
to move the room in or out. If help is available a
second person cranking on the other handle
simultaneously will greatly speed up the process.
At no point in the cranking process should you let
one side get more than 2 inches (50 mm) ahead of
the other. The most effective way to retract the
room using a single person is to crank one side
ahead of the other, then crank the other side in
(“walk” the room in).
Further Information
See the DigiSync Slideout Room operating
guide included in your Owner InfoCase for
further instructions and troubleshooting
information.
Crank-In Mode - Model 327L only
If the room will not retract using the buttons
and the mechanism is apparently malfunctioning,
you may need to manually crank the room in to
the travel position.
•
Use a ratchet wrench with a 7/16” socket on
the motor gearshaft to manually crank the
room inward.
•
The motor/gear assembly is located beneath
the vehicle near the rear ‘ram’ shaft of the
slideout room, just ahead of the driver side
rear tires.
Model 327L - View of motor/gear
assembly from ground