SECTION 10
SLIDEOUT
10-4
only if there is not a motor failure or full
electrical system failure.
To override the encoder
and enter the Manual Mode, press and hold the
RESET button until the two LEDs begin to flash.
While in the Manual Mode each of the two,
room slide arms are activated by pressing and
holding the IN and OUT buttons. The “OUT”
button will retract the front arm. The “IN” button
will retract the back arm. Both IN and OUT
buttons may be held down at the same time to
simultaneously activate both arms to retract the
room. If one side of the room gets ahead of the
other, release that button until the other arm
catches up. The current limiting feature of the
control still functions in the Manual Mode so
each side can be fully retracted until it stops.
Once the room has been retracted, the control
will return to the automatic mode after 60
seconds. You can manually return to automatic
mode by pressing the stop button.
In the event of a total system failure where
Manual Mode cannot be used, two crank handles
may be used to retract or extend the room.
EMERGENCY RETRACTION
Front Slideout Crank-In Mode
If the room will not retract using the buttons
and the mechanism is apparently malfunctioning,
you may need to manually crank the room in to
the travel position. The cranks are stored on clips
on the wall of an exterior storage compartment.
The crank sockets are located behind covers
on the lower portion of the room on the outside of
the coach. Your coach may have one of the two
types of covers shown.
Type A - Twin Arm
-
covers on lower face of
room (photo 1A): Pry out the snap-in screw cover
(photo 2A) and remove the screw to take off the
cover plate.
The crank socket is shown in photo 3.
CAUTION
Never let one side get more than 2 inches
(50 mm) ahead of the other while
retracting manually.
Slideout Crank Storage (typical)