13-3
SECTION 13
SLIDEOUT ROOM
14 - SLIDEO
UT R
OOM
13
- SLIDEOUT ROOM
•
If the batteries and breakers are okay, there
may be a failure in the mechanism or electri-
cal system. See “Manual Retracting Instruc-
tions” for help.
Slideout Room Extension
Emergency Crank-In Procedure
(Use only when room will not retract
using control switch)
If a failure occurs in the slideout electrical or
mechanical systems, and the room will not retract
using the control switch, you can manually re-
tract the room using the emergency crank assem-
bly described below.
The pump is located on a bracket attached to
the chassis frame beneath the coach about mid-
way on the left side of the vehicle, just ahead of
the rear wheels.
Step 1 - Relieve Hydraulic Line Pressure
•
Open the hydraulic pump slideout solenoid-
valves to release hydraulic line pressure and
let fluid bypass into the fluid reservoir. The
pump is located under the coach just ahead of
the driver side rear wheels.
NOTE: The
slideout room
solenoid has a small
1/4”
nut
at the end of the valve shaft that
requires you to use a 1/4” nut driver tool
that is built into the end of the hydraulic
pump oil cap.
See the Operator’s manual included in
your InfoCase for specific instructions
on which valves to open for front or rear
slideout rooms and what additional pre-
cautions to follow.
•
Open all of the slideout solenoid valves (with
1/4” nuts on the ends) to relieve hydraulic
line pressure. (See Step 1 under “slideout
Room Emergency Crank-In” on previous
page.)
DO NOT LOOSEN NUTS MORE
THAN 4 FULL TURNS.
•
pletely open (counterclockwise).
Step 2 - Install Winch Crank Assembly and
Straps
The winch assembly is generally stored in the
left rear cargo compartment.
Slideout Breaker
Stop engine, place transmission in
park position and apply parking brake
before lying beneath vehicle for this
procedure.
WARNING
