8-3
SECTION 8
LP GAS SYSTEM
8 - LP SYSTEM
If the Alarm Sounds
If the alarm sounds, do not touch any electri-
cal switches. Immediately turn off the main LP
tank valve and all LP appliances, open all win-
dows and roof vents, and leave the coach until
the alarm stops sounding.
If the alarm keeps sounding at regular inter-
vals, a leak may be present. Contact your dealer
or an LP gas service center to have the problem
corrected before using the LP system again.
Power Connection
The LP gas alarm is powered by the coach bat-
teries. If the auxiliary battery switch is shut off or
the battery cable is disconnected from the batter-
ies, the alarm will not work. The LP gas alarm
circuit breaker or fuse is located on the 12-volt
house electrical load center (breaker panel).
Because the LP gas alarm is connected direct-
ly to the auxiliary battery, it is always drawing a
small amount of current. Even though this current
draw is slight, it could drain the coach battery
during storage periods when the house battery
will not be charged regularly by the engine or
shoreline. Turn the Aux. Batt switch OFF to
avoid current drain during storage periods.
Other Combustible Fumes or Vapors
This alarm is designed to detect the presence
of LP gas, however there are other combustible
fumes or vapors which may be detected by the
sensor. These include: alcohol, liquor, deodor-
ants, colognes, perfumes, wine, adhesives, lac-
quer, kerosene, gasoline, glues, most all cleaning
agents and the propellants of aerosol cans. Most
are lighter than air in their vapor state and will
only be detected when the area is closed up.
Glues and adhesives may exhaust hydrocarbon
vapors for months after they are applied. They
are easily activated by high temperatures. If you
close up an RV coach on a hot day, the chemicals
used in its construction may be detected for sev-
eral months after the coach was manufactured.
Further Information
See the manufacturer’s information entitled
“Your LP Gas Detector” in the Owner InfoCase
for further instructions on nuisance alarms and
care and testing of the LP gas detector.
SAFE USE OF THE LP GAS
SYSTEM
The LP system is designed and built with strict
adherence to federal, state and recreational
vehicle industry requirements for mobile LP gas
equipment.
For your safety, there are many safety devices
and backup systems installed, such as tank fill
overflow valves, an interior LP gas detector/
alarm, and an interior carbon monoxide (CO)
detector/alarm.
LP gas also contains an odor additive that you
can smell if LP is present in the air.
Listed below are a few precautions to observe
that will help you to use the LP gas system safely.
•
Exercise caution at all times. Be familiar with
the distinctive odor of LP gas. If a leak is sus-
pected, turn off the supply valve immediate-
ly. Have the LP gas system checked by your
dealer or other qualified LP gas service cen-
ter.
•
Do not tamper with the LP gas piping system,
pressure regulator or gas appliances. Service
and maintenance of LP gas system compo-
nents should be performed only by your deal-
er or a qualified LP gas service center.
•
Never attempt to connect natural gas to the
LP gas system.
Never use an open flame to test for
gas leaks. When testing for gas line
leaks with a soapy water solution, DO
NOT use a detergent containing
ammonia or chlorine. These sub-
stances may generate a chemical
reaction causing corrosion to gas
lines, resulting in dangerous leak con-
ditions.
WARNING
