SECTION 7 HEATING & AIR CONDITIONING
7-1
7
- HEA
TING &
AIR C
O
NDITIONING
LP GAS FURNACE
Start Up:
1. Open the LP gas tank valve by turning fully
counterclockwise.
2. Move thermostat switch from OFF to HEAT
and press the Temp Selector button (Up/
Down arrows) until the desired temperature
is shown on the display.
3. Furnace fan will start to blow soon after set-
ting thermostat.
4. After about 30 seconds, the furnace burner
will light.
5. The furnace will now cycle off and on auto-
matically as the thermostat demands just like
a household furnace.
NOTE: If heat does not come out of the heat
ducts after a minute or so the burner is
not lit. Turn thermostat off for 3-5
minutes, check to be sure tank valve is
open and tank is not out of fuel, then try
steps 2-4 again. If it still will not light
after three attempts, go to Shut Down
steps and contact your dealer or a local
RV service center.
To Shut Down:
1. Slide thermostat switch to OFF position.
2. Close LP tank valve.
NOTE: Metal coatings used during manufacture
of the furnace burner parts may smoke
when the furnace is used for the first
time, which may also set off your smoke
alarm. If this happens, provide adequate
ventilation of the smoke to avoid a nui-
sance smoke alarm at this time. We do
not recommend removing the smoke
alarm battery. If it were inadvertently left
disconnected, the smoke alarm would be
inoperative.
Further Information
Please see the furnace operating instructions
provided in your Owner InfoCase for further
information, including operating precautions,
and periodic maintenance. See the Coach Main-
tenance Schedule at the back of this manual for
recommended intervals.
