SECTION 5
DASH / AUTO
5-2
HEADLIGHT BEAM CHANGE AND
TURN SIGNALS
Move multi-function lever upward for right
turn signal and downward for left turn signal.
Pull end of handle toward you to switch high
beam to low, or low beam to high.
WINDSHIELD WIPERS AND
WIPER DELAY
See your Ford chassis operating guide for
complete operating information.
HAZARD WARNING FLASHER
The hazard warning flasher provides addition-
al safety when the vehicle must be stopped on the
side of the roadway and presents a possible haz-
ard to other motorists. When the flasher is on, it
serves as a warning to the other drivers to ap-
proach and overtake your vehicle with caution.
The front directional signals and the taillights
will flash intermittently when the flashers are in
operation. The hazard warning flashers will not
operate when the service brake pedal is
depressed. The turn signal will not operate when
the flashers are on. When it is necessary to leave
the vehicle, the flasher system will continue to
operate with the ignition key removed.
CRUISE CONTROL
The electronic speed control (cruise) allows
you to maintain a steady speed and relieve driv-
ing strain while traveling long distances.
See your chassis operator manual for com-
plete instructions and precautions on the cruise
control.
COMFORT CONTROLS
Controls for the air conditioner, heater, de-
froster and vent are all combined into one control
panel. Refer to the following instructions for use
of individual controls.
FAN SWITCH -
Smallest dot is lowest air
movement; Largest dot is maximum air move-
ment. Fan will run at set speed when mode knob
is in any position except Off. When mode knob is
set to Off, the fan will not run.
Do not operate the cruise control on
icy or extremely wet roads, winding
roads, in heavy traffic, or in any other
traffic situation where a constant
speed cannot be maintained.
WARNING
Temp
Control
Mode
Control
