SECTION 8
APPLIANCES & INTERIOR FEATURES
8-2
Start-Up Instructions - Gas Mode
The control panel is located between the
freezer compartment and fresh food compart-
ment. It contains mode and temperature switches
and LED indicators. The On and Gas indicators
illuminate to indicate the refrigerator’s operating
mode.
The ON/OFF button turns the refrigerator
On or OFf. If the button is pressed, it will turn
the refrigerator On and set the mode to AUTO.
The temperature selector switch controls the
refrigerator and freezer temperature during both
gas and electric operation. Slide the switch to
select the desired temperature setting..
During operation in the AUTO mode, when
a higher priority power source becomes avail-
able, the operating controls will cease using the
current power source and will switch to the
higher priority power source. For example, if
AC electric becomes available while the refrig-
erator is operating in the AUTO LP GAS mode,
the refrigerator will switch to AUTO AC opera-
tion.
If an operating mode is not functional, its
corresponding indicator will flash and the refrig-
erator will attempt to operate in a lower power
priority source. If a lower power priority source
is not available, the indicator will continue to
flash, and the refrigerator will cease operation
until the energy source is corrected. Refer to the
“Diagnostic” section on page 7 of the “Norcold
Refrigerator Operator’s Guide” in your blue
binder.
AUTO and MANUAL Modes - Gas
Operation Only
If the gas does not ignite within 30 seconds,
which may occur on initial start-up, the refriger-
ator’s gas valve will automatically close and the
operating controls will select an alternate power
source (AUTO Mode) or revert to a stand-by
mode in which the GAS indicator flashes. The
indicator continues to flash until the refrigerator
is turned OFF and then ON. If the gas does not
ignite after several attempts, check the input gas
supply, or consult with your dealer or a Norcold
authorized service center.
Backup Operating System (“BOS”)
Your refrigerator features a Backup Operat-
ing System which keeps the refrigerator cool in
the event of a failure of the refrigerator’s operat-
ing controls. If a failure occurs, the TEMP SET
LED flashes and refrigerator switches to the
BOS mode. This mode provides refrigeration
until the refrigerator is serviced. The fresh food
and freezer compartment temperatures should be
monitored to prevent over-freezing or thawing
of refrigerator contents when operating in the
BOS mode. If the refrigerator temperature is too
cold, adjust the thermostat to the left in single
LED increments. If the refrigerator temperature
is too warm, adjust the thermostat to the right in
single LED increments. Let the refrigerator
operate at the new setting for one hour before
rechecking the freezer and fresh food compart-
ment temperatures. (Frequent door opening pre-
vents the temperatures from stabilizing.)
Although the refrigerator can operate in this
mode, Norcold recommends that you seek ser-
vice to restore manual operation as soon as prac-
Содержание 2004 Chalet
