7-3
SECTION 7
PLUMBING SYSTEMS
1. Prepare a chlorine solution using 1 gallon of
water and 1/4 cup of household bleach
(sodium hypochlorite solution). With tank
empty, pour chlorine solution into the tank.
Use 1 gallon solution for each 15 gallons of
tank capacity. This procedure will result in a
residual chlorine concentration of 50 ppm in
the water system. If a 100 ppm concentration
is required as discussed in item 3, use 1/2
cup of household bleach with 1 gallon of
water to prepare the chlorine solution. One
gallon of the solution should be used for
each 15 gallons of tank capacity.
2. Complete filling of tank with fresh water.
Open each faucet and run the water until a
distinct odor of chlorine can be detected in
the water discharged. Do not forget the hot
water taps.
3. Allow the system to stand at least 4 hours
when disinfecting with 50 ppm residual
chlorine. If a shorter time period is desired,
then a 100 ppm chlorine concentration
should be permitted to stand in the system
for at least 1 hour.
4. Drain and flush with fresh water.
EXTERNAL WATER
SUPPLY (“City Water”)
To connect to an external source:
1. Turn the demand pump switch to off.
2. Attach a hose from the external water source
to the city water connection in the utility
compartment or on the left side of your
vehicle.
3. Turn on the external water source.
When connected to an outside source of
water, the water bypasses the demand pump and
storage tank and supplies pressure directly to
individual faucets and toilet. A check valve built
into the pump prevents water from entering the
pump and filling the storage tank.
NOTE: Because city water pressure varies from
location to location, we recommend
using an
in-line water pressure regula-
tor
to prevent damage to any compo-
nents, connections and seals in your
fresh water system.
A water pressure regulator may be
obtained from any well stocked RV
dealership retail center and some retail
discount centers. These devices simply
connect in-line between the supply hose
and the city water input on the coach.
We recommend a regulator that controls
water pressure to
40 psi maximum
.
To disconnect from the external source:
1. Turn the external source off.
2. Open a faucet inside the vehicle to relieve
line pressure.
3. Disconnect the hose from the vehicle and
replace the cap on the connection.
SHOWER HOSE VACUUM BREAKER
After using the shower, you may notice water
dripping from the shower faucet assembly. The
dripping results when vacuum in the shower hose
(after closing the shower faucet) slowly releases
Chlorine is poisonous - recap bottle
and clean utensils after use.
Never use automotive type antifreeze
in your potable water system as it is
poisonous.
WARNING
Содержание 2004 Chalet
