Winmate R15ID3S-65A1FTE, Быстрый старт

Страница: 15 / 32

9
INSTALLATION
Wiring Requirements
The following common safety precautions should be observed before installing
any electronic device:

Strive to use separate, non-intersecting paths to route power and
networking wires. If power wiring and device wiring paths must cross make
sure the wires are perpendicular at the intersection point.

Keep the wires separated according to interface. The rule of thumb is that
wiring that shares similar electrical characteristics may be bundled together.

Do not bundle input wiring with output wiring. Keep them separate.

When necessary, it is strongly advised that you label wiring to all devices in
the system.
CAUTION

Do not run signal or communication wiring and power wiring in the same
conduit. To avoid interference, wires with different signal characteristics
(i.e., different interfaces) should be routed separately.

Be sure to disconnect the power cord before installing and/or wiring your
device.

Verify the maximum possible current for each wire gauge, especially for the
power cords. Observe all electrical codes dictating the maximum current
allowable for each wire gauge.

If the current goes above the maximum ratings, the wiring could overheat,
causing serious damage to your equipment.

Be careful when handling the unit. When the unit is plugged in, the internal
components generate a lot of heat which may leave the outer casing too
hot to touch.