Winkhaus blueMatic EAV, Инструкция по установке, эксплуатации и обслуживанию

Страница: 76 / 92

Notice:
The programming of remote controls via this receiver is
not possible.
5044744 76
4
EN
Aug. Winkhaus GmbH & Co. KG
∙ Berkeser Straße 6 ∙ 98617 Meiningen
T +49 369 3950 - 0 ∙ www.winkhaus.de ∙ Subject to technical changes
blueMatic EAV Installation, Operating and
Maintenance Instructions
The wireless receiver saves the button of the wireless remote control in the
sequence entered.
• To programm, press the P1 button of the circuit board of the wireless
receiver.
• The green LED lights up.
• Release the P1 button.
• Then, press the button of the wireless remote control you would like to save.
• The LED turns off.
• The desired button of the wireless remote control has been programmed.
Teaching-in via the wireless receiver (Part-no. 2142897)
Partial deletion
• Press and hold the P1 button for about 2 seconds.
• When the green LED lights up, release the P1 button.
• Press the button of the wireless remote control you would like to delete.
• The deletion of the button is signaled by the flashing LED.
Delete-all
• Press and hold the P1 button until the green LED lights up.
• Release the P1 button.
• When the LED lights, press the P1 button again until both LED flash three
times.
The memory is full once 85 buttons have been saved in the wireless remote
control. Now it is not possible to save additional wireless remote controls.
This condition is indicated in the teach-in mode by both LED displays flashing
simultaneously three times.
Deleting via the wireless receiver